|
|
![03250008[1].jpg - I used a wire bender to bend the and brass rod. Then I inserted it into a brass sleeve for the side-to-side eye control.](03250008[1].jpg "Downsized Image [03250008[1].jpg - 54kB]") |
|
![03260003[1]](../thumbs/03260003[1].jpg "I used 10-24 x 2-1/2\" oval head..."){kind=small}
![03260001[1]](../thumbs/03260001[1].jpg "In order to keep the lower nut from..."){kind=small}
![03230002[1]](../thumbs/03230002[1].jpg "This is a shot of the final fitting..."){kind=small}
![03230005[1]](../thumbs/03230005[1].jpg "I drilled pilot holes to check for..."){kind=small}
![03250007[1]](../thumbs/03250007[1].jpg "I chose a side-to-side eye movement...."){kind=small}
![03270002[1]](../thumbs/03270002[1].jpg "Here I'm prefitting the eye control..."){kind=small}
![03270010[1]](../thumbs/03270010[1].jpg "Good fixturing helps!"){kind=small}
![03270017[1]](../thumbs/03270017[1].jpg "Step back and take a look."){kind=small}
![03310004[1]](../thumbs/03310004[1].jpg "These are the pre cut parts that I'm..."){kind=small}
| I used a wire bender to bend the and brass rod. Then I inserted it into a brass sleeve for the side-to-side eye control. |
| Total images: 60 | Last update: 1/15/08 12:23 PM | Help |
|
|
|
|
| I used a wire bender to bend the and brass rod. Then I inserted it into a brass sleeve for the side-to-side eye control. |
| Total images: 60 | Last update: 1/15/08 12:23 PM | Help |