|
|
![03260003[1].jpg - I used 10-24 x 2-1/2" oval head brass machine screws as pivot bearings for the eyeballs. The eyeballs will then be mounted to a 1/4" plywood strip then assembled into the head. This technique allows for removal later if necessary. I slotted one of the mounting holes on the plywood plate (side to side) +/- 1/16" for adjustment purposes.](03260003[1].jpg "Downsized Image [03260003[1].jpg - 69kB]") |
|
![03230009[1]](../thumbs/03230009[1].jpg "I fit the eyeballs to the fixture..."){kind=small}
![03250005[1]](../thumbs/03250005[1].jpg "I used 3/8\" hobby wood to make..."){kind=small}
![03250006[1]](../thumbs/03250006[1].jpg "I needed to do some sanding to..."){kind=small}
![03230001[1]](../thumbs/03230001[1].jpg "Here's where I fit the eyes before I..."){kind=small}
![03250001[1]](../thumbs/03250001[1].jpg "I used a standasd 82 deg. countersink..."){kind=small}
![03260001[1]](../thumbs/03260001[1].jpg "In order to keep the lower nut from..."){kind=small}
![03230002[1]](../thumbs/03230002[1].jpg "This is a shot of the final fitting..."){kind=small}
![03230005[1]](../thumbs/03230005[1].jpg "I drilled pilot holes to check for..."){kind=small}
![03250008[1]](../thumbs/03250008[1].jpg "I used a wire bender to bend the and..."){kind=small}
| I used 10-24 x 2-1/2" oval head brass machine screws as pivot bearings for the eyeballs. The eyeballs will then be mounted to a 1/4" plywood strip then assembled into the head. This technique allows for removal later if necessary. I slotted one of the mounting holes on the plywood plate (side to side) +/- 1/16" for adjustment purposes. |
| Total images: 60 | Last update: 1/15/08 12:23 PM | Help |